Spiders can walk up walls, across ceilings and over glass, which seems to defy gravity. The answer is mostly not glue. Many spiders grip with fine leg hairs that press close to a surface, with weak molecular attractions between those hairs and the surface, and with claws at the end of each leg. This guide explains how each part works, how spiders let go, and what limits their grip.
Tiny hairs and close contact
The tips of a spider’s legs are covered with many fine hairs, called setae. Each hair can split into even finer branches, called setules. Some spiders have dense pads of hairs, known as scopulae, on their feet. When a spider presses its feet onto a surface, these hairs get very close to it, and weak attractive forces called van der Waals forces act between the hairs and the surface. Each contact is tiny, but together they can hold a lot of weight.
Claws for rough surfaces
Most spiders also have one or more claws at the tip of each leg. On rough surfaces, such as bark, brick and plaster, the claws can hook into tiny bumps and cracks. Smooth surfaces such as glass depend more on the hairs. Spiders differ in how many claws they carry. Some orb weavers have a third, smaller claw in addition to two main claws, which is often thought to help them grip silk, though the details vary by species.
Letting go quickly
Sticking is only half the job. Spiders do not need to pull hard to lift a foot. By changing the angle at which the hairs meet the surface, they can peel each foot off, much like lifting the corner of a sticky note.
Safety lines: dragline silk
Many spiders produce dragline silk, a strong thread that stays attached to the spider. The dragline acts as a safety line. If a spider loses its grip or falls, the line can catch it, which lets it climb back up. Spiders also use draglines to move between places, which is a separate use of the same silk. For what silk can do besides catching prey, see do spiders ever run out of webbing?
Why spiders can walk on glass and ceilings
Glass is very smooth, so claws cannot hook into it. Grip on glass depends mostly on the hairs and the close contact they make with a flat surface. This is why many spiders can walk across glass. Ceilings work on the same principle, because the hairs grip the surface whichever way the spider is facing.
What can reduce a spider’s grip
Anything that comes between the hairs and the surface may reduce grip. Dust, pollen, oils and water can all interfere, and very wet or very dusty surfaces may be harder for a spider to climb. Damage to the hairs may also make a spider less sure-footed. These are reasonable explanations rather than settled findings, and most spiders manage well in ordinary conditions. For how spiders avoid sticking to their own silk, see why do spiders get caught in their own webs?